cancel
Showing results for 
Search instead for 
Did you mean: 

Is there an image file to program the STM32100B-EVAL board (MB871 Rev.B)? I have the board but a blank display is all that happens on power-up. Also, is there any User Manual and other Documentation for this old but attractive board. Thanks in advance.

Ned.
Associate III
 
1 ACCEPTED SOLUTION

Accepted Solutions
Ned.
Associate III

Again Clive, I am in your debt; Cheers, Ned.

Have a GREAT end of year break.

View solution in original post

4 REPLIES 4
Ned.
Associate III

Again Clive, I am in your debt; Cheers, Ned.

Have a GREAT end of year break.

Thanks Clive, got it (I think, ... the commentary appears to be in German, but it looks good; most certainly better than I had).
Cheers Clive,
Ned.
n 22/12/2019 1:20 pm, ST Community wrote:
Ned.
Associate III

Clive the Master of ST Legacy. One must ponder the frustration level of "old" ST board users without St Clive having their 'back'! Yet again you have saved me from having to TRASH an (originally) expensive, and quite capable board. I quit programming etc about 10 - 15 years ago to concentrate on my job in Australia's 'Defence Science and Technology Organisation' as it was then known as then, and have since retired and am trying at getting back into replacing the RTC batteries and breathing life back into my significant stock of ST boards. Their (ST's) 'Long Term Support Policy' could do with a kick in the 'lower layer' as their products remain great, but the software 'hidden' to all but the most knowledgeable . The sup[port in Australia, last time I bothered to try it was, as always, pathetic.

Again St Clive, Thank You,

Cheers, Peter Kelly.