Hi everyone, can anyone explain me how to program my nucleo stm32f103 RB board with stlink v2 programmer

[Stephan Abraham]

Posted on December 07, 2017 at 06:34

Hi please help me with programming nucleo stm32f103 board with external stlink v2 programmer

[AvaTar]

Posted on December 07, 2017 at 11:16

What, exactly, is the problem ?

The following website host a lot of documentations:

http://www.st.com/en/evaluation-tools/nucleo-f103rb.html

 

Have you tried UM1727, the 'Getting started' manual ?

[Stephan Abraham]

Posted on December 08, 2017 at 06:18

Thanks for the reply, actually I just want to program my custom board with stm32f103c8 chip using stlink v2 programmer but i'am repeatedly getting the error message ' target not found ' what will be the possible causes for the above.

[AvaTar]

Posted on December 08, 2017 at 16:18

'Target not found' means the ST-Link works, but the programming/debugging tool cannot connect to the target.

What tool you talk about ?

Settings are correct (ST-Link, SWD) ?

Checked the voltages at the target supply (VDD) according to the schematics ?

Some jumpers pulled that need to be set ?

Before I forget it - had it worked before, i.e. could you have blown it ?