L297 stepper driver help
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2017-04-19 3:26 PM
Posted on April 20, 2017 at 00:26
Hi All
I need to put L297 stepper driver in 'wave drive mode' permanently. I connect HALf/FULL pin 19 to GND but it work in 'NORMAL DRIVE MODE' by default.
I tried to connect pin 19 to low in even state and get the 'wave drive mode' on but when restart the driver it go back to 'normal drive mode'.
please i need a solution to stand on 'wave drive mode' permanently.
Labels:
- Labels:
-
Motor Control Hardware
This discussion is locked. Please start a new topic to ask your question.
0 REPLIES 0
