How to Avoid OverCurrent Error using STSW-SPIN3204 Library ?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2020-04-18 4:17 PM
- I am using STEVAL-SPIN3204 development Board & using STM motor Library STSW-SPIN3204 .I am using a Maxon Motor with 12V DC input voltage.
- I am successfully able to run motor at 14k RPM but when I try to run motor at 25K RPM , my motor stalls & hits over-current error . I shouldn't be hitting this error as Motor is only drawing 0.4 Amps at this time.
- How can I avoid this error and stop my motor from Stalling ?
Any help in this matter will be really helpful .
Regards & Thank you.
Labels:
- Labels:
-
Motor Control Hardware
This discussion is locked. Please start a new topic to ask your question.
0 REPLIES 0
