About samuel_zhang

samuel_zhang · 2021-09-12

Tested on : one pieces of NUCLEO-L152RE evm board.I could create one DFU project(NUCLEO-L152-DFU) together with one APP project(NUCLEO-L152-BLINK) in STM32CUBEIDE towards STM32L152. I could upgrade firmware in STM32CUBEPROGRAMMER as well. After upgra...

samuel_zhang · 2015-11-02

Posted on November 03, 2015 at 03:14Dear all:I wonder how can I flash firmware image from PC through uart port (uart1/2/3) in stm32l476-discovery board.It is said in reference manual ''nBoot1'' should be set to 1 which represents so called ''Boot0''...

samuel_zhang · 2021-09-29

Please see the purchase link below:https://detail.tmall.com/item.htm?id=629908291799&spm=a1z09.2.0.0.7e692e8dSNiPES&_u=u1k5qcbd1c5

samuel_zhang · 2021-09-29

I took use of one 4PIN-to-USB cable to connect the board to PC.The pin definition is : D+ (CN10-12), D-(CN10-14) and GND-(CN10-9).

samuel_zhang · 2021-09-28

For each of the projects, if you run it standalone in debug mode (in STM32CUBEIDE), everything is just fine.However, if you program both of them (two hex files: bootloader to 0x800000, app to 0x810000), just log information of bootloader will show on...

samuel_zhang · 2021-09-14

Today I tried with the offical DFU example in "STM32CubeL1" and found that it was perfect during upgrading App firmware file ("STM32L152xE_NUCLEO_SysTick_0x08007000.dfu").The project is located in the folder "STM32CubeL1-master\Projects\NUCLEO-L152...

samuel_zhang · 2021-09-13

Thanks Bruno!!!The password is "123456".Please download it and decompress.

User statistics

User Activity

How to generate a valid DFU project in STM32CUBEIDE

How to flash firmware image through uart in stm32l476-discovery

Re: How to generate a valid DFU project in STM32CUBEIDE

Re: How to generate a valid DFU project in STM32CUBEIDE

Re: How to generate a valid DFU project in STM32CUBEIDE

Re: How to generate a valid DFU project in STM32CUBEIDE

Re: How to generate a valid DFU project in STM32CUBEIDE