About jeremyc123

jeremyc123 · 2023-09-29

Hello,I am currently using a custom-built board designed to the nRF24L01+ specification and using the same exact circuit provided in their datasheet. It is connected to my STM32F103 through SPI. I am currently using this library to test out this boar...

jeremyc123 · 2023-10-03

Sure, its the same one that you provided in your example. Both devices use this address: static const uint8_t address[HAL_NRF_AW_5BYTES] = { 0x33, 0x44, 0x55, 0x66, 0x01 };

jeremyc123 · 2023-10-03

Tried your code out, still no communication between devices. The device, when transmitting a packet, sets itself into the RF_BUSY state, and shortly thereafter into the RF_MAX_RT state. Meanwhile, the other device never enters the RF_RX_DR state. Her...

jeremyc123 · 2023-10-02

Not a library I have tested before, I tried with multiple libraries now and I am still not seeing any positive results. I tried lowering the clock speed and pulsing the CE but still no results.

jeremyc123 · 2023-10-02

Definitely should have started there. I was able to get my hands on a spectrum analyzer and I confirmed that there was nothing being transmitted at all. I'll go ahead and try Richard's solution and see if I get any luck. I'll also mess with the STM's...

jeremyc123 · 2023-10-02

I switched to a completely new example, no cigar. I realized in my circuit that I wired the IREF incorrectly to 3.3v instead of to ground. I removed the resistor and let IREF float and there was no change. I then wired IREF properly over a 22k to GND...

User statistics

User Activity

nRF24L01+ receiver problems

Re: nRF24L01+ receiver problems

Re: nRF24L01+ receiver problems

Re: nRF24L01+ receiver problems

Re: nRF24L01+ receiver problems

Re: nRF24L01+ receiver problems