About SBurc

SBurc · 2021-03-21

SBurc · 2021-03-10

We (Steven Burck and Haim Kleinman) have prepared the setups for tomorrows workshops, however, Steven is quarantined till next week and won't be able to make it, and Haim will not arrive to the site until 10AM CET. We have a third engineer who was p...

SBurc · 2020-10-08

I just solved a bug in my software, and can't quite understand how it happened. My code is a built in hardware test for our board, and a bootloader, which communicates with a serial bus and downloads different compoents to different memories. One o...

SBurc · 2019-08-29

This is a new issue involved in running from SRAM. I recently posted an issue:https://community.st.com/s/question/0D50X0000BDnc5pSQB/stm32f7-uart5-issueand this is a second, possibly related issue.The software I am writing is a Built-in-Test and boot...

SBurc · 2019-08-19

Before I explain the problem, I have to give some background. Our project went through a long stage of Proof-of-design, in which a maintenance program was written which tests all the interfaces. Part of this incuded BIT routines for those interfaces....

SBurc · 2021-03-10

Mistake in the earlier mail due to misunderstanding on the phone. Haim will arrive at the office tomorrow somethime between 9-10 Israel time, which is nearly right for the 8:30 CET start, and certainly for the 9:00 start. Tools are ready at the off...

SBurc · 2021-03-10

Quick change - Haim will be there (the times are CET, so he won't be late). I am still in quarantine (and away from where the board is), so I cancelled for tomorrow and re-registered for the 25th. Thanks.

SBurc · 2020-10-08

AFAIK it doesn't touch them from powerup. If I recall correctly, you need to set the enable bits in the CCR of the SCB, and I don't.

SBurc · 2019-08-29

Here is the code:bool InitTemperatureSensor(uint8_t which, uint16_t Configuration, float llimit, float hlimit){ HAL_StatusTypeDef status = HAL_OK; uint16_t addr = DT_SLAVE_ADDR_0; int16_t Lowlimit; int16_t Highlimit; bool result = true; bool Wr...

SBurc · 2019-08-19

Just a note to anyone looking at this: I wrote earlier "There is also an SPI driven device which is giving another issue, I'm looking into it as well."... well, It is not an issue, I had to add a couple of lines of code to dis-inhibit some lines, th...

User statistics

User Activity

Received a mail that I have lost my seat because I didn't purchase board. I did, for an earlier workshop, then I moved the date to the 25th.

Can I join a later workshop?

Question regarding use of AXIM vs ITCM.

Issue with running from SRAM

STM32F7 UART5 issue

Re: Can I join a later workshop?

Re: Can I join a later workshop?

Re: Question regarding use of AXIM vs ITCM.

Re: Issue with running from SRAM

Re: STM32F7 UART5 issue