About Ondrej HOLY

Ondrej HOLY · 2023-12-15

Ondrej HOLY · 2021-01-05

How to turn on a motor - Example with MCSDK & Cube IDE: “FOC duration” fault or/and "Software error"1. Pre-work I have followed all the steps presented in the Motor control Getting started: Generation from MC Workbench and compilation in STM32CubeID...

Ondrej HOLY · 2022-11-01

It is Online Support System.If you enter a question there a ST expert answer it.

Ondrej HOLY · 2022-10-31

Please use OLS system on following link https://my.st.com/ols.

Ondrej HOLY · 2022-10-05

Dear SJuntYou have not received answer because you have fill your question to strange place.This Community channel was created for Q&A after ACIM solution webinar dedicated for EMEA and US region.This is not standart support channel.Please use OLS sy...

Ondrej HOLY · 2021-09-29

Hello.1)You have to have in mind that the FW for Motor Profiler (MP) is a bit specific and it is a bit difficult to prepare it for all kinds of motors.I recommend to you reduce the used current for profiling and fit relevant maximum speed of motor.Th...

Ondrej HOLY · 2017-07-19

Posted on July 19, 2017 at 11:47Dear Jan,I have no information about the plan of manual target reset in ST-Link Utility.Have a nice day, Ondrej

User statistics

User Activity

MC SDK Webinar Q&A

How to turn on a motor - Example with MCSDK & Cube IDE: “FOC duration” fault or/and "Software error"

Re: I am using X-NUCLEO-IHM08M1 NUCLEO-F446RE Motor Profiler 5.4.8 motor>>48v 600w not run

Re: I am using X-NUCLEO-IHM08M1 NUCLEO-F446RE Motor Profiler 5.4.8 motor>>48v 600w not run

Re: I am using X-NUCLEO-IHM08M1 NUCLEO-F446RE Motor Profiler 5.4.8 motor>>48v 600w not run

Re: Hi, I Use NUCLEOF446RE and X-NUCLEO-IHM08M1 for running a motor. It works for a motor with 24V power supply. But however, if I use 36V power supply and run motor profiler to estimate the parameters. It fails to rotate. Need Suggestions?

Re: Fail to program STM32F413 using ST-Link Utility (Sector 1 is erased automatically)