Posted on February 06, 2018 at 06:15HELLO, I use the F446zet6 bxCAN to receive the message from pCAN , and found bxCAN no ACK in receive ending.Could you please let me know How to resolve this problem?
Posted on February 02, 2018 at 18:32Hello, I run the CAN loopback example project by NUCLEO-F446ZE. And find a problem, may I to set the r1 and r0 ? I read the RM0390, no message about it. Could you please let me know How to set the r1 & r0 bits?
Posted on February 03, 2018 at 12:41I find a solution to this issue. Don't care the r1 or r0 value.When I run the Extented Remote Frame, I set the DLC is [1111], and there isn't [1] bit stuff on the bit stream waveform.
Posted on February 03, 2018 at 07:54When I run the Extented Remote Frame and DLC is 0, I hope to set r1 & r0 to needn't [1] bit stuff. If I set r0 'recessive' , and DLC is 0 , there isn't [1] bit stuff.
Posted on December 31, 2017 at 07:36Thanks.I think, there are some incorrects on my F446-PCB, and I will check my schematic. Next, I will study F446's datasheet, and modify my schematic for Regulator Off.