Hi all,I am using STM32F303RB with iHM08M1 to control a BLDC motor.I want to startup my motor from zero speed using FOC, but the motor shakes at the beginning.I have tried to increase Vq, but the motor will have a big vibration if Vq is set to high, ...

Hi,I'm using STM32F303RB with ihm08m1 to drive a 36V BLDC motor. When I start motor, a high frequency sound (like a high pitch beep) is being made in the motor. The sound is a problem and very annoying, is there any way or solution to avoid this soun...

Hi all,I am using F303re to control an e-bike motor. I use GPIO PA6 connected to a speed sensor located on the wheel of e-bike.Every time the wheel takes a loop, an interrupt is sent from the speed sensor. Below is GPIO setting: GPIO_InitStruct.Pin =...

Posted on March 23, 2017 at 08:23Hi everyone,I was trying to download firmware in system memory mode via USART using the STM Flash Loader Demonstrator (version 2.8.0). However, there is no '.STMap' memory map file for STM32F722RE/ZE.Could anyone pro...