Problems running the I-cube-lrwan1 at_slave example on the B-L072Z-LRWAN1 board
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2021-08-05 7:46 AM
After flashing the firmware and connecting to the uart pins, I can get some lora settings when resetting the MCU but when i try to send at-commands i get no response. Any help appreciated
Labels:
- Labels:
-
LoRa
-
STM32L0 Series
This discussion is locked. Please start a new topic to ask your question.
0 REPLIES 0
