ILI9806E 5-inch LCD is connected to stm32f469 development board.
LCD is connected to MIPI interface.
And I used TouchGFX to mark the picture.
It created and ran a test program that displayed multiple pictures every one second.
A few minutes later, the picture came out and was no longer marked.
I saw the internal action with debugging, but it was doing the internal action.
It just didn't seem to show on the LCD screen.
I changed it because it seems to be an LCD clock problem, but it's the same result.
In this case, can you tell me which part to look at first?
and Can you show me how to calculate the settings below if you have any data?
PhyTimings.ClockLaneHS2LPTime = 33;
PhyTimings.ClockLaneLP2HSTime = 30;
PhyTimings.DataLaneHS2LPTime = 11;
PhyTimings.DataLaneLP2HSTime = 21;
PhyTimings.DataLaneMaxReadTime = 0;
PhyTimings.StopWaitTime = 7;
Thank you for reading my writing.
