VCP Demo Project Available with STM32_USB-FS-Device_Lib_V4.0.0 Not Working
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2014-04-09 4:16 AM
Posted on April 09, 2014 at 13:16
Hi Guys,
I am trying to run VCP project on STM32F103RET6 after some modification it's not working fine. Modification done are 1) Not configured USB disconnect pin as I don't have one in my Eval kit. 2) HSE configuration to 16MHz as am using external oscillator of 16MHz. 3) USB PLL Clock is configured for 48MHz. Still the demo project isn't working. USB ISR get's executed and also at times USB status (bDeviceState) is attached . Still I don't see same on my PC side. Can anyone suggest me for same ?Regards
,
Omji Mishra
This discussion is locked. Please start a new topic to ask your question.
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2014-04-09 4:38 AM
Posted on April 09, 2014 at 13:38
[DEAD LINK /public/STe2ecommunities/mcu/Lists/cortex_mx_stm32/Flat.aspx?RootFolder=/public/STe2ecommunities/mcu/Lists/cortex_mx_stm32/Virtual%20Com%20Port%20for%20STM32F103XC&FolderCTID=0x01200200770978C69A1141439FE559EB459D7580009C4E14902C3CDE46A77F0FFD06506F5B&TopicsView=https://my.st.com/public/STe2ecommunities/mcu/Lists/cortex_mx_stm32/AllItems.aspx¤tviews=46]Previous, related thread
Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..
Up vote any posts that you find helpful, it shows what's working..
