Forum Posts
STPMxx availability
Hi, I'm developing a product that will use the stpm32 and stpm34 chip. But the stock at farnell, mouser and RS are gone. On the ST website the status is active bus its hard go get my hands on a coulple of chips. even the st-store does't have them in ...
How to calibrate the STPM32
Hi,if i read the voltage and current from STPM32 through UART.for zero voltage I am getting 2v and some current.please let me know this to make zero reading initially. How to calibrate the voltage and current,power?how to calculate average voltage an...
How validate on sensortile(STEVAL-STLCS01V1)??
I want to validate on target(STEVAL-STLCS01V1) my model. I connect Sensortile(STEVAL-STLCS01) with STM32L476RG(Nucleo-L476RG).Validation on NUCLEO works properly. But, validation on Sensortile don`t works. The results as shown above appear.So, I won...
LIS3DSH alternate for LIS3DH? Our PCB is set up for LIS3DH. We do not use external ADC functions (Pins 13, 15, 16). If we substitute LIS3DSH on to the same board, is it required to ground Pin 13, Pin 15,16 or can we possibly leave them open?
This question is prompted by an availability issue for the LIS3DH