Posted on May 29, 2017 at 13:33Hello All, I am working on SPC560B54L5 board using SPC5studio version 5.2.3.I can able to write to C-flash memory using Flashprogram() api of flash driver component. In addition to that I also want to read byte by byte...
Posted on June 14, 2018 at 14:41Hi I am designing a Locomotive application with my customer, we have selected part# SPC560P54L3BEABY for 3.3V application. Now the end customer demands 5V application too. I learnt that the same series doesn't have a ...
Posted on June 01, 2018 at 15:20Hi, I'm looking for the BSDL file for the SPC574K72E7, Does anybody have this file?Thanks in advance!
Posted on June 01, 2018 at 23:46Hi,I'm sorry, maybe i'm not on the right section. I'm looking for a complete datasheet for Cartesio STA2062A chip, and cant find anywhere. only find a small resume, and I'm looking for more complete information about ...
Posted on April 30, 2018 at 22:24I have DO-160 testing to do on some avionics units. This certification is destructive, and I frankly do not know if the SPC will survive the MOPS in my particular application. A lot of this is empirical [not analys...
Posted on April 12, 2018 at 17:46Will the STM32 series be certified ISO26262 (ASIL-B) in the near future?Thanks.
Posted on April 09, 2018 at 14:42Hello Forums,I am working on SPC570Sx 32-bit processor.I facing the issue with the UART Idle line.In our application software has to detect the wake up pattern for Diagnostic Tool(Fast Init).we don't want to use the ...
Posted on April 10, 2018 at 11:22Hifor a concept car I need to drive a SPI based LED strip (ws2812) . In this project RGB information to drive the LEDs will be received via can protocol.What is the simplest automotive ST controller whioch I can use ...
Posted on February 23, 2018 at 10:14I have a DPM configuration for SPC56EL70. I initially had some trouble getting the debugger to connect to the target ( could connect fine in LSM.) The problem had to do with not clearing the LSM_DPMB bit. Erwan...
Posted on February 20, 2018 at 08:36I am wanting to run in DPM . I use SPC5Studio to create a .wsx configuration to debug with, but I get the following failure when I try to connect to the target:----------------------------------------------------...