Target unknown error 32 in STM32N6

[chanchal94]

I am working with STM32N6570-DK. My code is building fine , suddenly a hard fault has started coming. I have tried updating firmware, resetting the board, unplugging and reconnecting it, But debugger is getting stopped after sometime.

[chanchal94]

Hello Ben

This problem is gone after I again flashed the binaries from cube programmer and did some changes in debugger settings. Some problem is still there but this abrupt jump to outside memory is gone. 
The problem in detail I have posted on this thread, If you have any idea about this?

https://community.st.com/t5/stm32-mcus/how-to-debug-stm32n6-using-stm32cubeide/ta-p/800547