The interface firmware FAILED to reset/halt the target MCU
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2024-07-05 1:37 AM
I connected the Sx1278 lora module to the nucleo-f207 development board. and the st890cdr integrated circuit on the development board started to heat up. When I reconnected the STM development board to the PC, a Fail file was created and the text "The interface firmware FAILED to reset/halt the target MCU" appeared. What should I do to fix this situation?
0 REPLIES 0
