FAQs
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

STM32 USB port connection problem.

urath
Associate III

‎2019-05-16 06:31 AM

Hello all,

I have problem with my USB application. I am using Atollic and CubeMx on Windows 10 system.

The USB connection gets disconnected when I enter debug mode for STM32F446RE nucleo board.

Then I tried using Nucleo H743ZI board, the board is detected but the USB is not detected. Am I missing something?

Labels:
0 Kudos
3 REPLIES 3
Michael E
ST Employee

‎2019-05-16 06:54 AM

Do you speak about USB STLink?

Install the last USB/VCP driver here --> https://www.st.com/content/st_com/en/products/development-tools/software-development-tools/stm32-software-development-tools/stm32-utilities/stsw-link009.html

And be sure that your STLinkV2 firmware is up to date

To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.

0 Kudos
urath
Associate III

‎2019-05-16 07:05 AM

No that should not be the case, if so I would not be ale to see for the first board my USB!! For STM32F446RE....

Still I will try

0 Kudos
urath
Associate III

‎2019-05-17 03:00 AM

the same problem I also tried to post on discussions

https://community.st.com/s/question/0D50X0000AnsGZmSQM/attolic-studio-debug-mode-usb-connection-problem

0 Kudos
Top