This file was selected by help|install new software|add|archive|<select .zip file>What is the correct method to install new software like cubemx
stm32 board: stm32f446reHi, recently, I bought the expansion board X-NUCLEO-GNSS1A1, and I've managed to communicate it with USART. However, I have a hard time to do that with I2C, it stuck at slave address transferring. In the beginning, I thought t...
I have used stm l4984d ic for pfc control and got all the necessary parameters within range but still no pulse is generated by pfc ic. What can be the possible errors In my design so that I can rectify them
Posted on February 20, 2018 at 13:48Yesterday I started to work with the EVAL-IPFC01V1.Can I program the STNRGPF01 with the ST-LINK/V2 through the SWIM connector J2?Or I must use the UART J3 with the adapter in the box? In this case what is the corr...
eDesignSuite is able to provide only the value of the inductance, I would like to know even the value of the resistance at 13.56MHz.
Worked in burst mode from 50V HV, then lower output voltage till 120VAC input, and almost totally powered off when input VAC above 135V. The ZCD resistive divider is 82 kOhm and 12 kOhm. Transfomer has 100 turns, 7 and 7 turns respectively. Lpri abou...
There are our test and verify procedure of defective IC as following:Our terminal client found IC function disabled issues(no voltage drop value and no voltage output) and feedback------- engineer found disabled IC through confirmation and analysis( ...
It seems not possible to found over classic distribution channels, there is some chance to found it somewhere?Thank.Best regardsFabio
am working with the EVAL-IPFC01V1 card, I already have the .Hex file with eDesign to program but when opening the application it does not show any COM port, I am using a conventional USB to TTL cable directly to the control board, it is necessary to...
Values like 2.1 for a voltage can not be entered in to the comparator calculator