Hello ST,I’m attempting to integrate the STEVAL-STRKT01 into my system.I need to issue NMEA commands to the Teseo .I’m connected into the UART over CN503 (TX,RX,GND only) and I can see the serial chatter.For example, I want to Stop the STAGPS engine ...
Dear sir/madam,where is the right place to program stnrgpf01 online by edesignsuite? I logged into eDesignSuite but didnt see the choice of stnrgpf01.Thanks,Michael
ONSEMI MPNNC7WZ16P6X NL27WZ16DFT2G NC7SZ74K8X NL17SZ74USG NLV17SZ74USGNC7SZ125P5X NL17SZ125DFT2GNC7SZ74K8XNC7SZ27P6X, SN74LVC1G27DCKR
I have reviewed above MPN, but suffix "S" Details not reflected in Ordering Information in datasheet.Let me know "S" Denotes to "TS110-8SA1?
Hello, right now i am working with a STA8090 DevKit to test some things with the Teseo LIV3F. Unfortunatly, the software documentation is very inconsistent.For example in UM2399 Rev5 May 2020, there is the command$PSTMCFGCONST (page 151/376), which a...
I'm new to your listings thus a 1st step, next step, etc. approach is needed to avoid getting parts that will not solve this issue.I have already downloaded:ST Motor Pilot v0.9.9ST Motor Control WorkbenchST Motor Profilerand am reviewing your softwar...
Hi,The bit [1:0] for STUSB4500 registry CC_STATUS(0x11) is labeled as CC1_STATE: (available when CONNECT_result =1) 00: Reserved 01: SNK.Default (Above minimum vRd-Connect) 10: SNK.Power1.5 (Above minimum vRd-Connect) 11: SNK.Power3.0 (Above minimum...