I am working with STEVAL-IDP005V1 and Nucleo64 boards and STEVAL board already programmed, i interface STEVAL-IDP005V1 to ST-LINK of nucleo board & i drop-drag the .bin file into disk but not able to get the output on serial monitor
The STEVAL-IDP005V1 is programmed with Condition Monitoring firmware.
steps:
- i download & install the USB drivers on windows(ex: STSW-LINK009) then i connected the STEVAL-IDP005V1 board to st-link programmer with other need connections
- i check the pin configurations on Nucleo board to support st-link debugger & upgarde the firmware (STSW-LINK007) and reset the my device.
- then drag and drop the application .bin file into disk(when we connect stm32f401re device it display like a drive or disk), it willautomatically resets the device but not showing any output on serial monitor.
- please help me & i follow the below attached links
thanks
https://www.st.com/content/ccc/resource/technical/document/user_manual/group1/41/68/d4/a7/8e/62/4d/bb/DM00518672/files/DM00518672.pdf/jcr:content/translations/en.DM00518672.pdf
https://www.st.com/content/ccc/resource/sales_and_marketing/presentation/product_presentation/group0/47/a2/91/a0/fe/ca/42/89/steval-bfa001v1b_getting_started_guide/files/steval-bfa001v1b_quick_start_guide.pdf/jcr:content/translations/en.steval-bfa001v1b_quick_start_guide.pdf
