IKS01A2 register read help
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2017-10-19 1:14 AM
Posted on October 19, 2017 at 10:14
Hello, my name is Domenico, I'm a mechanical engineer and I am working on a standalone vehicle dynamic model for my master thesis using STM32F401RE board + IKS01A2 shield. I am new to hardware programming so I'm experiencing a lot of issues trying to read accelerometer and gyroscope signals. I am using 'ST Nucleo Board Support from Simulink Coder' (
) . Do i need any kind of setup before reading from register addresses? Do I need to write some registers to set read mode? Any help is appreciated, thanks for your time. Best regards, Domenico Perillo.#stm32f401 #register-access #lsm6ds0 #gyroscope #x-nucleo-iks01a2 #accelerometer #mems
Labels:
- Labels:
-
Accelerometers
-
STM32F4 Series
0 REPLIES 0
