Browse
STMicroelectronics Community
FAQs
Sign In
Product forums
STM32 MCUs
STM32 MCUs Products
STM32 MCUs Boards and hardware tools
STM32 MCUs Software development tools
STM32 MCUs Embedded software
STM32 MCUs TouchGFX and GUI
STM32 MCUs Motor control
STM32 MCUs Security
STM32 MCUs Wireless
Others: STM32 MCUs related
STM32 MPUs
STM32 MPUs Products
STM32 MPUs Boards and hardware tools
STM32 MPUs Embedded software and solutions
STM32 MPUs Software development tools
MEMS and sensors
MEMS (sensors)
Imaging (sensors)
Automotive and Transportation
Automotive MCUs
AutoDevKit Ecosystem
GNSS positioning
Edge AI
Interface and connectivity ICs
Power management
ST25 NFC/RFID tags and readers
STM8 MCUs
Others: hardware and software
Analog and audio
Knowledge base
STM32 MCUs
STM32 MPUs
MEMS and sensors
Analog and audio
EMI filtering and signal conditioning
Interface and connectivity ICs
Power management
Quality & reliability
Learning
STM32 online courses
About
Community guidelines
Feedback forum
Community blog
Super User Program
About the program
Developer news
All community
This category
This board
Knowledge base
Users
Products
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Search instead for
Did you mean:
STMicroelectronics Community
Product forums
Interface and connectivity ICs
Hi, I have a board with Bluenrg2 chip with UART pi...
Options
Subscribe to RSS Feed
Mark Topic as New
Mark Topic as Read
Float this Topic for Current User
Bookmark
Subscribe
Mute
Printer Friendly Page
Hi, I have a board with Bluenrg2 chip with UART pins connected to FT232RQ for USB-UART bridge. Will the DTM uart firmware that comes with the BlueNRG-1_2 DK 3.2.1 work with this setup?
sg.14
Associate
Options
Mark as New
Bookmark
Subscribe
Mute
Subscribe to RSS Feed
Permalink
Print
Email to a Friend
Report Inappropriate Content
2020-08-25
6:37 AM
Labels:
Labels:
Low Power RF Solutions
All forum topics
Previous Topic
Next Topic
This discussion is locked. Please start a new topic to ask your question.
0 REPLIES
0
Reply
Related Content
changing current and voltage rating along with current protection in B-G431B-ESC1 firmware
in
STM32 MCUs Motor control
2025-04-29
error when trying connection to target(SPC58NH-DISP) using AEK-MCU-SPC5LNKU(debugger) and UDE Starterkit 5.02.04
in
Automotive MCUs
2025-04-28
STM32CubeAI: INTERNAL ERROR: E801(HwIOError): Invalid firmware
in
Edge AI
2025-04-28
STM32H723ZGT6 USB_OTG_HS in FS Mode Not Detected by PC (No External Oscillator)
in
STM32 MCUs Products
2025-04-28
I'm trying to code NUCLEO-H755ZI-Q in Arduino IDE but it doesn't work.
in
Others: STM32 MCUs related
2025-04-28
