How to flash aek-com-blev1 through AEK-MCU-C4MLIT1?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2020-06-24 11:53 PM
I know how to burn the firmware but it is not required i think. I downloaded the sw mentioned in this link: https://www.st.com/resource/en/data_brief/stsw-aekble.pdf
but it is not gettting imported or compiled in spc5 studio so i can open it later in UDE for flashing the ble board later.
Also where is this connector on ble board J2541409? I am not able to find proper user guides or manual.
This discussion is locked. Please start a new topic to ask your question.
0 REPLIES 0
