Hello -I have the STM32MP257x-EV1 up and running the base image. I have included the layers for the Ethernet switch and TSN. I am trying to understand the embedded Ethernet Switch better. I am working with the assumption that I can plug in two endpoi...
how to connect stm32mpu157d-dk to the display can somebody please help me
Hello, I am working on bringing up the STM32MP257F-EV1 Development board and have a question. I was wondering if the SD card is actually required or if it and the EMMC are completely interchangeable and the whole board can work off completely off th...
i am planning to build an dpoae device so which one do u prefer STM32MP157D-DK1 processor or STM32H7A3 microcontroller is enough? for STM32MP157D-DK1 can u suggest some videos on how to use it ,the ide for it how to access the GPIOS .u can also sugg...
can you please suggest me a best stm32processor board which has adc and dac and usb port, ethernet wifi which uses stm32cube ide
Hello! Thank you for opening this post.This is my first time to fully build the Distribution Package according to the guide on ST Wiki, and I have gained a lot from it.But now I have a question to ask for help. After I burned the generated image afte...
Hello everyone, I am trying to program the STM32MP157 to control a simple LED using Keil software. However, I am encountering numerous errors during the compilation process, particularly with the setup files. Additionally, the controller name appears...
We have a custom STM32MP157 board running Linux that is not booting over eMMC. The STM32MP157 image boots from SD card on SDMMC1 but not from a Toshiba THGBMNG5D1LBAIL eMMC chip connected to SDMMC2. We have confirmed the Boot pins are correct, and th...
Hi i am struggling in how to boot from the EMMC not from the SD card , i used the custom board where my emmc is connected to SDMMC2 port , i did changes into the device tree i enable the sdmmc2, but i do not know how to boot from the emmc ?,actually ...
Hi all,I own a STM32MP135F-DK board and started to write a simple firmware on it based on RTX threads.I'd like to use USART1 port as simple terminal interface with the board.I chose USART1 cause it is present on CN8 connector (RX + TX) and cause the...