STM32F105RC CANBUS & USB Conflict
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2015-07-29 2:27 AM
Posted on July 29, 2015 at 11:27
Hi guys,
I have been searching for a long time, but still not found a solutions for my problem.My MCU is STM32F105RCT6.When I try to use both CANBUS & USB drivers at the same time on same project, some times USB driver could not found USB flash memory , sometimes the CANBUS hardware always goes to bit recessive error.is there any one who succeeded to run before CANBUS and USB at the same time on connectivity line MCU ?Or do you have any suggession for my problem.Thanks a lot. #stm32f105rc-can-bus-usb_otg
Labels:
- Labels:
-
USB
This discussion is locked. Please start a new topic to ask your question.
0 REPLIES 0
