How to make the STM32-MAT , embedded target for Simulink visible to Simulink?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-08-10 4:22 AM
I downloaded the software from https://www.st.com/en/development-tools/stm32-mat-target.html, but I do not see the blocks in Simulink.
Solved! Go to Solution.
Labels:
- Labels:
-
STM32-MatTarget
This discussion is locked. Please start a new topic to ask your question.
1 ACCEPTED SOLUTION
Accepted Solutions
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-08-10 4:35 AM
I found that the document that described how to do is in the installation folder.
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-08-10 4:35 AM
I found that the document that described how to do is in the installation folder.
