Good evening. We are working at a school project by STM32. We are usign Arduino IDE to control ST boards. We found how to set NUCLEO-F401RE and it works perfectly, but nothing to do with X-NUCLEO-53L0A1, P-NUCLEO-IKA02A1 and X-NUCLEO-IHM03A1.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-04-24 11:37 AM
For X-NUCLEO-53L0A1, P-NUCLEO-IKA02A1 and X-NUCLEO-IHM03A1, we find libraries, but they don't work. Could you kindly help us? Thank you.
Solved! Go to Solution.
- Labels:
-
STM32duino
-
STM32F4 Series
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-04-24 9:13 PM
You might be better off asking that on the Stm32duino pages: https://www.stm32duino.com/
Under the "STM32F4Boards"-section.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-04-24 9:13 PM
You might be better off asking that on the Stm32duino pages: https://www.stm32duino.com/
Under the "STM32F4Boards"-section.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-04-24 11:56 PM
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-04-26 9:47 AM
By-the-way I can't login with the credentials that I use here... There is not way to register too, so I send an e-mail...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-04-28 4:14 AM
Of course not. It's an enthusiasts group. It has nothing whatsoever to do with ST-Micro.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-04-28 4:24 AM
I checked a little closer, and there are bad news - the site is going to be closed this spring.
