C:\Users\User\ST\BlueNRG GUI 4.7.1\Firmware\STEVAL-IDB012V1
I'm using BlueNRG-LPS STEVAL-IDB012V1(stm32 with bluenrg-lps) to flash an external module using DTM_Uart.hex file.
I want to flash an external module using the BlueNRG GUI with pins(Rx, Tx, SW_DIO, SW_CLK, VCC, GND), but its throwing me an error: "Exit Flashboard: Excepotion ID1: Auto baudrate functionality failed".
And if I am flashing the internally placed bluenrg module then it starts flashing and done successfully.
So, please suggest me how to flash an external module by insulating internally placed module on STEVAL-IDB012V1 board.
.png){kind=link}