Dear All,
my name is Mario and I am working the the STEVAL-IDB008V1M board with WiseStudio IDE, version: 1.3.1_R.
I want to debug my application with ST-LINK V2 but I have no experience with Wise Studio.
Could kindly anybody give me some piece of advice for debug configuration?
I configured a debug configuration according to the Wise-Studio instructions but the following error occurs:
Open On-Chip Debugger 0.10.0+dev-01002-g983a95ff-dirty (2020-01-08-15:00)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
adapter
adapter assert |deassert [srst|trst [assert|deassert srst|trst]]
adapter deassert |assert [srst|trst [deassert|assert srst|trst]]
adapter usb
adapter usb location [<bus>-port[.port]...]
adapter_khz [khz]
adapter_name
adapter_nsrst_assert_width [milliseconds]
adapter_nsrst_delay [milliseconds]
interface driver_name
interface_list
reset_config [none|trst_only|srst_only|trst_and_srst]
[srst_pulls_trst|trst_pulls_srst|combined|separate]
[srst_gates_jtag|srst_nogate] [trst_push_pull|trst_open_drain]
[srst_push_pull|srst_open_drain]
[connect_deassert_srst|connect_assert_srst]
Error: invalid subcommand "driver st-link"
C:\WiSE-Studio\plugins\fr.ac6.ide.wise.core_1.3.1.202305151442\resources\openocd/interfaces/stlink-dap.cfg:11: Error:
in procedure 'script'
at file "embedded:startup.tcl", line 26
at file "BLE_RemoteControl Release.cfg", line 7
at file "C:\WiSE-Studio\plugins\fr.ac6.ide.wise.core_1.3.1.202305151442\resources\openocd/interfaces/stlink-dap.cfg", line 11
The error seems: invalid subcommand "driver st-link".
I kindly ask for your help to solve this problem.
Thanks in advance.
Best Regards,
Mario
