STM32H747-DISCO Core-Lock Problem Hello,I’m using the STM32H747. When I set the RCC power source to RCC → Power parameters → Supply source = LDO, the core locks up; if I select SMPS, there’s no issue.When I set CM7 to its maximum clock frequency (480 MHz) and CM4 to 240 MHz, the tool forces LDO and I can’t choose SMPS. In fact, for any CPU clock higher than 400 MHz, LDO becomes mandatory.When I run the MCU with LDO, I can’t operate at the maximum clock frequency. If the core locks up, I set BOOT=1 via R192 and perform a Full Chip Erase. After that, if I still keep LDO selected, I can connect once and program the device, but on the second programming attempt—or after unplugging and replugging the board—I get a “No target” error again. I see the same problem even at lower clock frequencies when LDO is selected.Previously, when I programmed the MCU at the maximum clock frequency, I did not encounter this issue. The code that used to run without problems at that time is now producing the same error today.Also, I’m attachin
