About Mike Wirth

Mike Wirth · 2020-12-17

Mike Wirth · 2020-12-17

Mike Wirth · 2020-12-10

Folks, I was pleased to attend this workshop in Santa Clara, CA, two years ago and receive the hardware (Nucleo-F302R8, X-Nucleo-IHM07M1, small BLDC motor and power adapter) and workshop software (bundled in an installer). Still have all of this, in...

Mike Wirth · 2020-02-29

Would appreciate getting copies of the briefing slides, list of HW and SW used, and installation/setup instructions. Thanks,Mike

Mike Wirth · 2020-02-07

Mike Wirth · 2020-12-21

Peter,Thanks for the quick and useful reply. Version 5.4.5 solves a troublesome quirk in linking to newer versions of MX during code generation.Still Windows only, apparently. Hoping for a cross-platform (i.e., Mac and Linux) version sometime.Mike

Mike Wirth · 2020-12-18

Cedric, Thanks for the quick and informative reply.After posting my question, I found a workaround. When MCWB "Generate" complains about not finding a compatible STM32CubeMX installation, go ahead and click the text to reinstall STM32CubeMX. Don't ...

Mike Wirth · 2020-12-12

Cristiana,Thanks for the prompt and informative reply. with the information you provided and some effort on my part, I think I've succeeded in installing a full set of software components in my Windows 10 VM so I can repeat the demos from the 2018 M...

Mike Wirth · 2020-02-07

Scratch that question. I downloaded an obsolete version (1.1.0) of STM32CubeIDE. The current version, 1.2.0 installs without error on macOS 15.3, Catalina and the IDE starts up fine.Mike

Mike Wirth · 2018-01-02

Posted on January 02, 2018 at 18:57John,Thanks. Will give all of these suggestions a try.Mike

User statistics

User Activity

Is the Motor Control Workbench 5.4.4 compatible with STM32 CubeMX 6.1.0? If so, why does the Project Generation tab in the workbench generate a "STM32CubeMX not found" response?

what is current version of STM32 Motor Control Workbench?

How to update 2018 STM32F3 Motor Control Hands-On Workshop to use current versions of software on Windows 10 and port to macOS Big Sur?

Your workshop, "Putting the right spin on Stepper and Brushless DC motors", in Santa Clara couple days ago was full, so I couldn't get in. But can I get the workshop materials?

When will STM32CubeIDE support be available for macOS 15 Catalina?

Re: what is current version of STM32 Motor Control Workbench?

Re: Is the Motor Control Workbench 5.4.4 compatible with STM32 CubeMX 6.1.0? If so, why does the Project Generation tab in the workbench generate a "STM32CubeMX not found" response?

Re: How to update 2018 STM32F3 Motor Control Hands-On Workshop to use current versions of software on Windows 10 and port to macOS Big Sur?

Re: When will STM32CubeIDE support be available for macOS 15 Catalina?

Re: Optical issues for use of VL53L0X ToF sensor