cancel
Showing results for 
Search instead for 
Did you mean: 

is there a way to use the STM32CubeMonitor-Power in a headless mode directly from cli? or any ideas to automate power measurement acquisitions using the X-NUCLEO-LPM01A board

Waelha
Associate II
 
1 ACCEPTED SOLUTION

Accepted Solutions
PDEFO.1
ST Employee

Hi,

The User manual UM2269 (um2269-getting-started-with-powershield-firmware-stmicroelectronics.pdf) describes the CLI available with the Powershield. CLI will allow you to command the powershield with an hyperterminal.

Regards

Philippe

View solution in original post

1 REPLY 1
PDEFO.1
ST Employee

Hi,

The User manual UM2269 (um2269-getting-started-with-powershield-firmware-stmicroelectronics.pdf) describes the CLI available with the Powershield. CLI will allow you to command the powershield with an hyperterminal.

Regards

Philippe