Is it possible to program the STEVAL-IDB008V1M module using by usb ?

COlva.1 · ‎2021-07-20

Hello

I just received my STEVAL-IDB008V1M evaluation kit. I have been trying to upload my code to the board for several hours after a successful compilation. But I always have this error message" no ST-LINK detected". I also installed the STLINK USB Driver but I still have the same error message.

Can someone help me fix the problem ? Thank you

TDK · ‎2021-07-20

That board does not have an on-board ST-Link like other ST boards.

The user manual describes how to program the board. One option is JTAG, the other is wireless.

https://www.st.com/resource/en/user_manual/um2071-bluenrg1-bluenrg2-development-kits-stmicroelectronics.pdf

If you feel a post has answered your question, please click "Accept as Solution".

View solution in original post

TDK · ‎2021-07-20

That board does not have an on-board ST-Link like other ST boards.

The user manual describes how to program the board. One option is JTAG, the other is wireless.

https://www.st.com/resource/en/user_manual/um2071-bluenrg1-bluenrg2-development-kits-stmicroelectronics.pdf

If you feel a post has answered your question, please click "Accept as Solution".

COlva.1 · ‎2021-07-20

Thank you for your quick reply!