Where to add the training data, .ucf into IMU sensor driver and add detection flow into IMU sensor driver once the gesture is detected?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2022-10-24 12:38 AM
Dear Sir,
After performing IMU MLC training process by UNICO GUI and coming out training data, .ucf, please advise us where to add the training data, .ucf into our ST IMU sensor driver and where to add detection flow into our IMU sensor once the gesture is detected. We will apply ST IMU sensor, LSM6DSOX which is support MLC.
Thanks.
Mike / mike.sun@quantatw.com
0 REPLIES 0
