I3G4250 Not Updating Data At The Right Rate

[deltaspacetechnologies]

I am using a I3G4250 on a custom PCB over I2C. When you first take data from it on restart it works but then after less than a second, it stops getting new data. It receives data exactly 25 times before stopping and sometimes receives about the same amount of packets more than 1 minute after.

Any help is appreciated,

Delta Space Technologies

[Federica Bossi · Accepted solution]

Hi @deltaspacetechnologies ,

Welcome to ST Community!

Can you share your schematic? And also a reg dump to check if your writings are ok.

Thanks