How to wire STEVAL-MKI197V1 to a muRata nRF development board: WSM-BL241-ADA-008DK.

Forum|Forum|5 years ago
January 27, 2021
2 replies
1589 views

The STEVAL-MKI197V1 has standard breadboard pins on it. The muRata dk (WSM-BL241-ADA-008DK) has available connection points in position JP4 - looks like the right place to attach. Is there a ribbon cable or adapter to connect these two boards together?? thank you! (see photos)

Accelerometers

This topic has been closed for replies.

Best answer by Eleon BORLINI

Hi @BGrap.1 ,

the STEVAL-MKI197V1 -and in general the DIL24 connector of ST sensors' STEVALs- has been designed to be compatible with the STEVAL-MKI109V3 motherboard (and the X-Nucleo expansions for the Sensors).

I don't think that the schematics are immediately compatible, but if you could remap the functions of the muRata nRF according to STEVAL-MKI197V1 schematic, you could make the two boards compatible.

-Eleon

Eleon BORLINIBest answer

ST Employee

Hi @BGrap.1 ,

the STEVAL-MKI197V1 -and in general the DIL24 connector of ST sensors' STEVALs- has been designed to be compatible with the STEVAL-MKI109V3 motherboard (and the X-Nucleo expansions for the Sensors).

I don't think that the schematics are immediately compatible, but if you could remap the functions of the muRata nRF according to STEVAL-MKI197V1 schematic, you could make the two boards compatible.

-Eleon

BGrap.1Author

Associate

Thanks for the fast reply. We did see the DIL24 connector on the motherboard (STEVAL-MKI109v3) and considered that but thought we would reach out to anyone who might have manually wired them together.

thanks!

Brian

Sign up

Login with SSO

Login to the community

Login with SSO