Skip to main content
RealityConjurer
Visitor II
Oct 31, 2019 7:30 PM UTC
Question

CubeProgrammer GUI works, but CLI -> "unsupported device (DevID - 0x0000)

I'm setting up toolchains and workflows and cannot get the CLI to read a non-zero deviceID.

I've tried updating drivers to latest and firmware to V2J35M26. Same Issue.

I've tried several different nucleo boards (of the F446 and F412 variety) and even an st-link v3 w/ some other boards and a F446, doesn't work.

I've tried version 2.1.0 and 2.2.0 of the programmer.

0690X00000ArWYQQA3.png

Please Advise.

This topic has been closed for replies.

2 replies

Nesrine.JLASSI
Visitor II
Nov 4, 2019 3:21 PM UTC

Hello @RealityConjurer​ 

I just tested the same scenario and i did not have any problems.

Could you please send me a screenshot that proves your firmware update to V2J35M26.0690X00000AresJQAR.png

Best regards,

Nesrine

Tesla DeLorean
Guru
Nov 4, 2019 4:14 PM UTC

Likely to be some situational dependency.

Avoid USB hubs and docking stations. DELL machines, and remote diagnostic utilities.

Try different cables, or ports on the machine. Try different make/model of machine, confirming if issue follows or not.

Tips, Buy me a coffee, or three.. PayPal Venmo (See Profile) Up vote any posts that you find helpful, it shows what's working..