Update Problem

After STM32CubeMX update from version 6.10.0 to 6.11.0 WorkBench give me and error (see picture Worckbench.jpg attached).

How to solve this problem ?

I don't find any configuration on Wokbench to specify new STM32CubeMX installation.

This topic has been closed for replies.

UniRobBest answer

Associate III

Thank you very much, I solve the problem.

STM32CubeMX was automatically update to 6.11.1 and STM32CubeIDE to 1.15.0 to.

The problem was that MotorControl Workbench was not automatically update .

Installing MotorControl Workbench 6.2.1 the problem is solved.

ST Technical Moderator

Hello @UniRob !

Thank you for bringing this issue to our attention, I will check it internally and get back to you as soon as possible.

Regards,

Souhaib

To give better visibility on the answered topics, please click on 'Best answer' on the reply which solved your issue or answered your question.

ST Technical Moderator

Hello @UniRob ,

A new version of CubeMX 6.11.1 has been released. Could you install it and check if the problem persists?

Thnx,