Solved
Change board selection after code generation
This is a question about STM32CubeIDE.
When creating a new STM32 project, you select the board, but is it possible to select the board again after customizing the auto-generated code for us?
This topic has been closed for replies.
Hello
@pass3master wrote:
When creating a new STM32 project, you select the board, but is it possible to select the board again after customizing the auto-generated code for us?
No.
Best Regards.
STTwo-32
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.