Skip to main content
Associate
Nov 4, 2026 1:15 PM UTC
Question

When using deep stop mode on the stm32wb09ke, setting the wakeup source to PWR_WAKEUP_BLEHOST or PWR_WAKEUP_BLE causes a reset and reboot.

When using deep stop mode on the stm32wb09ke, setting the wakeup source to PWR_WAKEUP_BLEHOST or PWR_WAKEUP_BLE causes a reset and reboot.

2 replies

ST Technical Moderator
Nov 5, 2026 1:59 PM UTC

Hello ​@xrds ,

In Deepstop mode, at wakeup, all the hardware resources located in the digital power domain that are OFF during Deepstop mode, are reset. The CPU reboots. This behavior is mentioned in the reference manual, and you can check the wakeup reason in the register of the power controller.

You can refer to the available example shows how to enter the Deepstop mode and wake up from this mode:

  • AN5977: How to build a Bluetooth® LE application with STM32WB0 MCUs
In order to give better visibility on the answered topics, please click on 'Best answer' on the reply which solved your issue or answered your question. Thanks
xrdsAuthor
Associate
Nov 6, 2026 1:39 AM UTC

we have a low-power Bluetooth device based on the STM32WB09KE in DEEPSTOP mode. Out of 10 devices, 9 run normally all the time, but one of them, after broadcasting normally for a while, keeps resetting and rebooting, unable to broadcast data properly, and then after some time it can broadcast again. During this process, I set the wake-up source for DEEPSTOP mode to PWR_WAKEUP_BLEHOST or PWR_WAKEUP_BLE and didn't use a watchdog.