How can I communicate between LoRa E5 mini and RYLR896(It is also LoRa Module).

[EŞimş.1]

It can be code or AT commands, doesn't matter.

[Tesla DeLorean]

In a raw point-to-point mode, or some how else?

You'd need consistent settings of frequency, bandwidth, code rate, spreading factor, preamble etc.

https://reyax.com/wp-content/uploads/2020/01/Lora-AT-Command-RYLR40x_RYLR89x_EN.pdf

In my application I just reprogrammed the STM32L151 and SX1276/SX1262 in the RYLR896 and RYLR900 respectively.

[EŞimş.1]

Hi Tesla DeLorean

Thanks for your answer. Actually, LoRa E5 mini is problem for me because the AT commands of RYLR896 is so clear to understand but in LoRa E5 is so different.

https://files.seeedstudio.com/products/317990687/res/LoRa-E5%20AT%20Command%20Specification_V1.0%20.pdf

This is AT Commands of LoRa E5. It has so different values and commands. I'm new on this card probably I have too much topics for researching =)

[Tesla DeLorean]

I think you'd need to use the TEST mode on the E5

[EŞimş.1]

You are right. It should be in test mode. But still there are some questions in my mind. Thanks a lot.