STM32F10C-Eval ethernet connector

[dorrachendoul]

Posted on July 01, 2013 at 10:41

Hi,

I connected the ethernet port of the STM32F10C-Eval with the Hub using an ethernet cable. But the ethernet port is not detected. What  could be wrong?

Thank you.

[Tesla DeLorean]

Posted on July 02, 2013 at 03:36

Is the PHY initialized?

[Thierry GUILHOT]

Posted on July 02, 2013 at 07:47

Hi,

This forum is related to STMTouch solutions offered by STMicroelectronics. To get more visibility on your question, I recommend you to post it on the generic STM32 forum.

Best Regards,

Thierry,

[dorrachendoul]

Posted on July 02, 2013 at 08:21

Hello,

Can you give me the link to ths forum?

[dorrachendoul]

Posted on July 02, 2013 at 08:23

Hello,

i didn't intialize anything, i thought that when i connect a cable to ethernet connector, a led will be blinking meaning that the cable is detected without inizializing anything. How can i do that ?

[Thierry GUILHOT]

Posted on July 02, 2013 at 10:19

Hello,

The STM32 forum link is available on the right hand side when viewing the STMTouch forum. You can also directly access to it using the below link:

[DEAD LINK /public/STe2ecommunities/mcu/Lists/cortex_mx_stm32/AllItems.aspx]https://my.st.com/public/STe2ecommunities/mcu/Lists/cortex_mx_stm32/AllItems.aspx

Best Regards,

Thierry,

[dorrachendoul]

Posted on July 02, 2013 at 10:47

Thank you .