STM32F0 CAN FIFO1

[Giu S]

Posted on June 12, 2017 at 17:08

Hello to all,

I'm new in STM32. I have to use the CAN peripheral on the STM32F091VCTx microcontroller.

I'm able to send messages and receive messages in the FIFO0, but if I try to use the FIFO1 the software go down and go in an 'infinite loop' that I don't know what does it means. I have the last version of CubeMx and I use AC6 IDE.

Could someone explain to me what is the problem with FIFO1? How I can use it?

Thank you very much. 

[Tesla DeLorean]

Posted on June 12, 2017 at 17:20

>>

go in an 'infinite loop'

Stopped in a debugger this where exactly? Hard Fault Handler, Default Handler?

[Giu S]

Posted on June 12, 2017 at 18:12

after this instruction (but only for FIFO1, because for FIFO0 it works good):

pRxMsg->IDE = CAN_RI0R_IDE & hcan->Instance->sFIFOMailBox[FIFONumber].RIR;

It goes here:

    .section .text.Default_Handler,'ax',%progbits

Default_Handler:

Infinite_Loop:

b Infinite_Loop

.size Default_Handler, .-Default_Handler

Thank you for your reply.

[Tesla DeLorean]

Posted on June 12, 2017 at 22:39

Check FIFONumber is in range.

Have an effective Hard Fault Handler routine

Make sure all IRQHandlers you need are correctly named and present