Skip to main content
SV.10
SV.10
Associate
May 12, 2023
Question

PA2 & PA3 are connected to the internal ST-Link controller, therefore not usable for TIM9 pwm output if any one konown how to configure ?

  • May 12, 2023
  • 3 replies
  • 1078 views

..

This topic has been closed for replies.

3 replies

waclawek.jan
waclawek.jan
Super User
May 12, 2023

Are you talking about a Nucleo board? There are solder bridges on it, which can be used to disconnect these two pins from the STLink. Read the User Manual to your board.

JW

SV.10
SV.10Author
Associate
May 13, 2023

yes Bro i don't know how to done it

Tesla DeLorean
Tesla DeLorean
Guru
May 12, 2023

You could just write the code..​

Tips, Buy me a coffee, or three.. PayPal Venmo (See Profile) Up vote any posts that you find helpful, it shows what's working..
Terms & ConditionsAccessibility statement