Is there an image file to program the STM32100B-EVAL board (MB871 Rev.B)? I have the board but a blank display is all that happens on power-up. Also, is there any User Manual and other Documentation for this old but attractive board. Thanks in advanc

[Ned.]

..

[Tesla DeLorean]

SW

https://drive.google.com/open?id=1j84_XyzYSUR5lPG1BbQjlvbryU7OEfSN

Doc

https://drive.google.com/open?id=1gCq1d-u0f1jSrynTWQy4etf2CgekKkTC

[Ned.]

Thanks Clive, got it (I think, ... the commentary appears to be in German, but it looks good; most certainly better than I had).
Cheers Clive,
Ned.
n 22/12/2019 1:20 pm, ST Community wrote:

[Ned.]

Again Clive, I am in your debt; Cheers, Ned.

Have a GREAT end of year break.

[Ned.]

Clive the Master of ST Legacy. One must ponder the frustration level of "old" ST board users without St Clive having their 'back'! Yet again you have saved me from having to TRASH an (originally) expensive, and quite capable board. I quit programming etc about 10 - 15 years ago to concentrate on my job in Australia's 'Defence Science and Technology Organisation' as it was then known as then, and have since retired and am trying at getting back into replacing the RTC batteries and breathing life back into my significant stock of ST boards. Their (ST's) 'Long Term Support Policy' could do with a kick in the 'lower layer' as their products remain great, but the software 'hidden' to all but the most knowledgeable . The sup[port in Australia, last time I bothered to try it was, as always, pathetic.

Again St Clive, Thank You,

Cheers, Peter Kelly.