Skip to main content
tejas_amp
Associate III
November 23, 2024
Question

OCP in STEVAL-ESC001V1 not supported in MC Workbench

OCP in STEVAL-ESC001V1 is mentioned in its user manual, but in MC Workbench while generating project, neither OCP nor Driver Protection support is present. Please clarify?

This topic has been closed for replies.

1 reply

GMA
GMA
ST Technical Moderator
November 25, 2024

Hello @tejas_amp,

This issue has been already reported, please check following post.

If you agree with the answer, please accept it by clicking on 'Best answer'.Best regards.GMA
Terms & ConditionsAccessibility statement