I am get this error message from ST Motor Pilot Profiler. I have tried clearing the memory and disconnecting power to the board but there is no change. Any information on how to go around this issue?

I am using the F302RB nucleo board and IHM07M1 motor driver.

This topic has been closed for replies.

Zied b.Best answer

ST Employee

hello, can you update your St-link using STM32CubeProgrammer then try again please

"If you agree with my answer, please accept it by clicking on ""Accept as solution""."

Zied b.Best answer

ST Employee

hello, can you update your St-link using STM32CubeProgrammer then try again please

"If you agree with my answer, please accept it by clicking on ""Accept as solution""."

Sign up