Hi All, How to configure Nuttx RTOS with NUCLEO-H743ZI2 board? And after configuration how to and where to start programming, means on STM32CubeIDE ?

[RGhat.1]

..

[Walid ZRELLI]

Hello @RGhat.1​ ,

Take a look at the following link : incubator-nuttx/boards/arm/stm32h7/nucleo-h743zi at master · apache/incubator-nuttx · GitHub

It might be helpful.

BeST Regards,

Walid

[RGhat.1]

HI,

The you have sent me is for Nucleo-H743ZI board and I'm using Nucleo-H743ZI2 board.

So when I port this Nuttx RTOS into my Nucleo-H743ZI2 board, is it possible to do programming and create our own driver using STM32CubeIDE?

Regards,

Rushikesh

[Walid ZRELLI]

Hello @RGhat.1​ 

Sorry, but your question is not very clear to me. Could you please provide more details?

Thanks in advance.