Skip to main content
Sn.17
Sn.17
Associate II
August 13, 2021
Solved

ST-LINK V2 Programmer NOT working for STM32G0B1KET6N

ST-LINK V2 Programmer NOT working for STM32G0B1KET6N

Kindly help me to upload the program

Here i attached the schematic for your reference.

This topic has been closed for replies.
Imen.DBest answer
ST Technical Moderator
August 13, 2021

Hello @Sn.17​ 

Try using latest release of STM32cubeProgrammer tool.

Check all connectors, USB cables and USB ports.

Make sure that your board is worked properly, maybe you can check with other boards.

I'm waiting for your update.

Please mark my answer as best by clicking on the "Select as Best" button if it fully solved your issue. This will help other users find this solution more quickly.

Imen

In order to give better visibility on the answered topics, please click on 'Best answer' on the reply which solved your issue or answered your question. Thanks
View in thread

3 replies

Imen.DBest answer
ST Technical Moderator
August 13, 2021

Hello @Sn.17​ 

Try using latest release of STM32cubeProgrammer tool.

Check all connectors, USB cables and USB ports.

Make sure that your board is worked properly, maybe you can check with other boards.

I'm waiting for your update.

Please mark my answer as best by clicking on the "Select as Best" button if it fully solved your issue. This will help other users find this solution more quickly.

Imen

In order to give better visibility on the answered topics, please click on 'Best answer' on the reply which solved your issue or answered your question. Thanks
Tesla DeLorean
Tesla DeLorean
Guru
August 13, 2021

ST-LINK Utilities? That won't work with the G0 series

Watch also SWD clock rate, the CM0(+) parts won't clock at higher speeds.

Don't see a schematic, but unlikely to be the issue

Tips, Buy me a coffee, or three.. PayPal Venmo (See Profile) Up vote any posts that you find helpful, it shows what's working..
MichaelSweden
MichaelSweden
Associate II
August 14, 2021

I'm using a STM32G0B1CCU6, so not exactly the same as you. However I can program my device via Serial Wire.

My ST-LINK V2 have firmware V2J36S7 and I'm using STM32CubeProgrammer v2.5.0 on a Linux PC.

Command: <path>/STM32_Programmer.sh -c port=SWD mode=UR -q -d build/<applicationname>.bin 0x8000000 -v -g

PS. SWD freq is 4000 KHz, I haven't touched it.

//Michael

Terms & ConditionsAccessibility statement